LIMITED TIME OFFER, WHILE SUPPLIES LAST: buy one 2h2o and get a FREE light mount.
SAVE 23% OFF MSRP ON KING CAGES WITH THE PURCHASE OF THIS PRODUCT; MAXIMUM DISCOUNT IS TWO CAGES PER MOUNT, SEE RELATED PRODUCTS BELOW.
The 2h2o Mounting System (patent pending) allows for the mounting of two cages for placement of water bottles and/or accessories in the handlebar area of most bicycles. Its pin and slot design uses linear and rotational adjustments so that mounted items can be optimally placed to maximize knee clearance and handlebar turning radius.
This product was designed by Luis Lopez, Machinist and Product Designer at Paragon Machine Works.
Compatibility: 1-1/8" steerer
Parts for Assembly:
The 2h2o Mounting System consists of 19 pieces (included with purchase):
1 each Offset Link Mount
2 each Link
2 each Cage Mount
1 each M6 x 50 SHCS
1 each M6 x 20 SHCS
4 each flat washers
2 each M6 x 25 BHCS
2 each M6 nuts
4 each serrated washers
2 stainless steel thimbles
Important Information:
Read through all instructions and refer to drawings prior to installation
This system was designed to be enjoyed within moderate riding conditions
Manufacturer is not responsible for items that have been installed improperly or used for something outside of their intended use
Weight limit per cage mount: 2 lbs
Tools Required:
Tools must be in very good condition to prevent damage to hardware.
4 mm hex wrench
10 mm combination wrench
Medium strength thread locker such as Blue Loctite